Home » Page 50

FTC Issues Consumer Alert on Magnuson-Moss Warranty Act

It’s illegal for a manufacturer to specify a specific brand of oil

It’s illegal for a manufacturer to suggest they will void a warranty due to some standard additive. This has been one of the most common recurring myths about synthetic oil; that it can somehow void your warranty. Harley Davidson did a particularly good job of perpetrating this misinformation. For example, a manufacturer can specify “20w-50” with a specific set of standards but they CANNOT specify a brand name product, or suggest that other brands will void a warranty. This act is the subject of a recent FTC alert. It’s good information

The Federal Trade Commission (FTC) recently issued a consumer alert clarifying that the Magnuson-Moss Warranty Act prohibits automobile manufacturers and dealers from denying warranty coverage based on use of an aftermarket product, unless they can show the product caused the damage or was installed incorrectly.

“The FTC’s statement should help those ILMA members, for example, who have decided not to license General Motors’ dexos™ engine oil,” said ILMA counsel Jeff Leiter. “Some ILMA members have complained to me that the automaker has made confusing statements about its new engine oil and warranty coverage for new vehicles. It makes sense to hand a customer a copy of the FTC consumer alert, showing that the use of equivalent products should not affect warranty coverage.”
The FTC consumer alert can be viewed at http://www.ftc.gov/bcp/edu/pubs/consumer/alerts/alt192.shtm

Share

Amsoil Bypass Filter Install–Ford Expedition

Free amsoil catalog 

Link to bypass filter kits.

image

 

The Dual Remote Filtration System (BMK23) was installed on a 2008 Ford Expedition equipped with a 5.4L V8. Since it’s 2WD, there is a lot of room for mounting in front of the axle, behind the front bumper. The kit comes with all the necessary hardware, but I custom made part of the bracket in order to fi t it where I wanted. A spin-on adapter was used to attach the feed and return lines to the engine. Installing the system behind the front bumper requires no more than 18” of hose for either line. The EaO15 Full Flow Filter and EaBP90 By-Pass Filter used sit well above the frame rails and are easy to get to. System capacity increased from seven quarts to almost nine.

imageimage

2008 Ford Expedition 5.4L V8 2WD The area behind the front bumper allows ample room
for installation.

image

Less than 18” of hose is required for either the feed
or return lines.

image

Filters are easy to access and sit well above the
frame rails.

Share

Wanderscheid Becomes First Four-Time AMSOIL World Champion

Wanderscheid Becomes First Four-Time AMSOIL World Champion

Buy Amsoil Snowmobile Products.



An exciting weekend of racing culminated in Wanderscheid
earning his record fourth AMSOIL World Championship.

The AMSOIL World Championship Snowmobile Derby took place January 13-16 at the AMSOIL Eagle River Derby Track in Eagle River, Wis. and featured one of the most exciting races in the event’s 48-year history, with Team AMSOIL ice oval racer P.J. Wanderscheid coming out on top and making history in the process.

The event kicked off Thursday with practice and time trials, where Wanderscheid clocked in third fastest. Friday featured the Friday Night Thunder program, where pole position in Sunday’s feature race was at stake. After winning his eight-lap heat race, Wanderscheid took the early lead in the 16-lap final and didn’t look back, taking the win, securing the pole position in Sunday’s feature and earning a day of rest and preparation on Saturday.



Wanderscheid celebrates his historic win.

Starting Sunday with practice laps, Wanderscheid clocked in with the fastest time. The World Championship race featured a different format this year, increasing from 25 to 30 laps that were split into two sections. Drivers raced 15 laps, took a five-minute pit session, then resumed the final 15 laps with a staggered start according to how drivers finished the first 15 laps.

Upon the start, AMSOIL-backed driver Gary Moyle jumped out to the early lead with Wanderscheid close behind. Moyle led the entire 15 laps, with Wanderscheid narrowing the gap slightly on lap 13. After the pit stop, Moyle and Wanderscheid thrilled fans with an epic battle for the title as they continually exchanged the lead. Wanderscheid took the lead for good on lap 29, taking the win and going down in history as the only racer to win four AMSOIL World Championships. Moyle took second, followed by ice oval racing legend Jacques Villeneuve.



Martin earned the Pro Stock and Pro Open
final wins on Sunday.

Team AMSOIL found further success on the snocross track, where AMSOIL racers swept the podium at the Friday Night Thunder Pro Stock final, with AMSOIL/Scheuring Speed Sports racer Robbie Malinoski taking the win, followed by AMSOIL/Judnick Motorsports racers Ross Martin and Mike Bauer in second and third respectively. Malinoski also took third in Friday’s Pro Open final behind Justin Broberg and Brett Turcotte.

On Sunday, Martin took the Pro Stock final win, followed by Malinoski in second, Kaven Benoit in third and AMSOIL/Scheuring Speed Sports racer Darrin Mees in fourth. Sunday’s Pro Open final featured an exciting battle between Martin and Turcotte, culminating with an awe-inspiring charge by Martin from the final turn to the finish line for the win. Turcotte finished second, Broberg third and Malinoski fourth.

Share

What’s Better — Synthetic Oil or Regular?

In today’s day and age, as oil changes continue to go up in price and now are routinely being added into warranty packages on new vehicles, it’s becoming more and more important to know just what they’re putting into your engine and how much you’re paying for. The automotive industry has advanced much in recent years, not only in the precision of the machining of engine components, but also in the precision of fuel injection and combustion for maximum fuel efficiency. But has oil changed that much? Is there really a reason why an oil change might now cost over $100 at the dealership, when not too long ago, oil changes were less than $20. Is there really that much of a difference between synthetic oil vs regular oil? The answer somewhat depends on what is being required by the warranty package of many of the newer vehicles. Many of the new warranty packages require the owner to get all of their oil changes done at the dealership, using the dealership’s own custom full synthetic brand for “maximum protection.” I call it “maximum cost” because they definitely charge you an arm and a leg for most warranty packages.

But as for those of us who don’t need to bring our cars into the dealership for simple work, is it really all that recommended to pay the extra money for the synthetic over the regular? In a lot of cases, going the route of full synthetic is a bit excessive. As we discussed earlier, with machining of engine components and the fine tuning of modern vehicles, oils have to do less and less work to lubricate and protect our engines. Not only that, but because of better formulation technologies and viscosity enhancers, today’s oils meet a higher standard and protect an engine much better than the oils of a few decades ago. Not only that, but machining technology has advanced greatly in the past 2 decades as well, meaning that the surfaces where friction happens are much more precise and internally stable.So from that standpoint, getting a full synthetic is a bit unnecessary. That being said however, many of us don’t drive around a brand new car and are instead driving something from the 90s. In this particular situation, going the route of full synthetic might be a good option in order to give your engine as much protection as humanly possible. That is the reason why many mechanics and oil change locations are beginning to go for a middle of the road solution. These days, I mostly get half synthetic and half regular oil when I go for an oil change. This is definitely a nice middle of the road solution, because it combines what I think is the best of regular and synthetic.

A lot of myths have developed in recent years surrounding synthetic oils. I’ve heard before that synthetic oil isn’t compatible with regular petroleum based oil, which is false. I’ve actually gotten oil changes before that were partially synthetic and partially regular. I’ve also heard people say that they’re worried that switching to synthetic oil might cause their seals to get damaged or that the switch might cause buildup and deposits to be left behind. Both of these rumors are also false, which your mechanic can tell you the next time you go in for an oil change. In most respects, synthetic oil acts almost identically with regular oil. Synthetic oil is simply designed to last longer. That’s the biggest difference. If you’re worried about using a different oil than what you’ve been using, ask the oil change professional the next time you go in for an oil change. They’ll obviously try and sell you on the more expensive brands, but you’ll be able to decide in the end what kind of oil to use.

Synthetic oil vs regular oil has been a battle going on for some time now. I hope you enjoyed reading this author’s opinion on it. For more in the automotive world, check out my other article on engine oil stop leak.

You can also see some comparisons here; http://syntheticoilvsregularoil.com/

Share

The AMX Carved Its Own Niche

The AMX is famous for being a touring sports car that was made by the American Motors Corporation or AMC around the years 1968 to 1970. There was a continued increase in the making of muscle cars around this time. There was also a demand for more high-performance luxury cars or GT in style and approach than the real sports car. Thus the AMX muscle car was launched to the market in order to compete with the Chevrolet Corvette, which was the only two-seater muscle car in the US during that particular period. However, the AMX really had its work cut out if it wanted to steal the spotlight from such a famous and beloved car. While it didn’t succeed, the AMX did carve out a nice niche for itself.

The name AMX came from the code of ‘American Motors eXperimental’ that was used on a concept vehicle as well as on 2 trial products that were shown on the ‘Project IV’ car which was used back in 1966

The AMX engine was a high-compression medium block 390 cubic inches, with a V8 that was optional. The car offered a great performance in spite of its affordable price. Although it had proved its outstanding performance and received an overwhelming reception from the media and car enthusiasts, the sales of AMX never increased. However, the automaker had better and larger objectives – to refocus the image of AMX on quality performance as well as to attract younger customers to visit their dealer showrooms. Fortunately, these broader goals were achieved successfully.

The manufacturing of the AMX’s muscle car was halted after three model years. And this resulted in the transfer of the present AMX signature design to a higher performance version of its four-seat sibling through 1974, which was known as the Javelin..

In 1965 when the original AMX models were modified by the American Motors Corporation, it was done with the use of the sophisticated styling studios under Charles Mashigan, the creative director. Robert Evans was the one who requested the AMX car to be put into the assembly immediately and this started the development programs for the production of the muscle car. Those special programs consisted of an enhanced Javelin and an entirely new car that was bodied with fiberglass. The enhanced Javelin was chosen in order to allow AMC to utilize its unibody assembly expertise and available technology to create quite an inexpensive adjustments to the Javelin.

Read more article just like this one, including the latest post about the 1965 mustang on the MuscleCarMonster.com.

Share